New !  IMPROVED THC MODEL

3 BIG improvements...
#1- 25X Faster response. Follows plate height changes more closely and faster than older models.
#2- Better stability. Improved electronics eliminates voltage "spikes" that used to cause jumps or dips.
#3- Better voltage isolation. No more worries about bad grounds and fuses that could damage the unit.
Dynatorch offers the "Technogon" Automatic Torch Height Control for your existing NON-Dynatorch plasma cutting machine.  It will work with any other control system, mount on any machine easily, and will work with almost any plasma cutter. (This unit is NOT required for Dynatorch Control Systems.  The Dynatorch Control has an AVHC built-in to it's standard package)


New heavy duty lifter station.  All machined components.
 

 

       

  • Operates from arc voltage.

  • Universal interface to almost any plasma cutter

  • Pierce height is user settable.

  • You can change cutting height while cutting.

  • An unmatched design for the price!

All for $2,145.00 with a one year warranty 

Why should I buy this product?

SAFETY!

The RIGHT way


 

Our voltage regulated guide will allow for automated operation, thereby eliminating all of the safety risks.

The WRONG way

How safe is this?

  • Eye Damage

  • Burns

  • Smoke Inhalation and Lung Damage

  • Electrocution

  • Entanglement in Moving Machine

  • Can you say "LAW-SUIT"?

PRODUCTIVITY & OPERATING COST

  • Are you wasting time watching a machine work or are you paying people to watch a machine work?
  • Scrapping parts due to poor cuts and "Blow Outs"?
  • Eating up consumables caused by "Crashes"?

QUALITY PARTS

  • Consistent good parts from consistent cut control
  • Reduced "Baby Sitting" so there is time available for other tasks
  • Less re-work

FEATURES

  • Simple Hookup
  • Universal, works off 110 to 230 volts AC on 50/60 Hz power
  • Arc voltage adjustable from 100-200 VDC before or during cutting
  • Pierce height adjustable from 0-1/2"
  • Unit auto-retracts after each cut to avoid tip-ups
  • 3-1/2" torch travel allows loading metal
  • Initial height sensing uses no external switches or contacts
  • Manual mode allows user flexibility with Pilot Arc Systems
    (switching to manual before or during cut allows arc to stay on over holes)
  • Unlimited lifetime tech support even if you bought it used.
  • Transferable to any other machine
  • Software and operating parameters are user adjustable
  • For more information see our Frequently Asked Questions