|
|
|
The
Dynatorch Tube
and Pipe
Cutting
Attachment
(Photo shows additional torch lifter slide, normally you would use the existing one from your Gantry. Machine pictured above shows how the Tube cutter would attach to the optional cutting table with it's optional red powder coated finish. Also shown is the optional Air Handler, shown with it's optional red powder coated finish. Exhaust fan is NOT included with the air handler) Dynatorch
offers one of the most exciting accessories in the plasma cutting arena.
Imagine being able to cut any pattern into round tubing or pipe.
Slots, spiral slots, circles squares, rectangles or any shape you can
imagine can be easily cut into a tube up to 14 inches in diameter.
Shapes are only the start, letters, words or numbers are equally
possible. Cutting tube/pipes to
specific lengths can be done quickly and accurately. Tube/pipe ends can be cut to angles or even cut to “fish
mouths” to prepare for accurate butt welds. The uses of this accessory in
the manufacturing or metal art world are only limited by the imagination. All parts needed
to adapt your Dynatorch cutting table and gantry to use the tube cutter are
provided. To convert from flat
sheet to tube cutting is a simple matter of moving the torch slide assembly to
the tube cut position and plug in
the tube cutter cable and you are ready to go. The Dynatorch
Posi-grip tube drive system assures a tight grip on even irregular or super
thin tubes providing accurate
cuts. Additional
software to aid in creating cutting files is provided at no additional cost. Tube
cutter specifications:
Give us a call to discuss this product further or check
out our videos
page to see this
amazing product in action.
|