The "Easy to Load" Drop Side Gantry driven by a Single X Axis Gear Motor

(Gantry is shown with the optional drop side table and the optional air handler, both with the optional powder coat finish. Exhaust fan is NOT included with the air handler)

Dynatorch offers an exciting array of top quality, fully assembled (not a kit) and tested gantry systems with a single Dynatorch Brushless Servo Drive on one end, and a cross shaft to drive the other end.  All our systems are dieven from both ends of the gantry to prevent crabbing of the gantry.  The single servo unit uses a cross shaft, the twin servo unit has no cross shaft, but two electronically connected motors instead.

The Single X Axis Drive system comes complete with Dynatorch software, all cabling, interface console, three Intelligent DC servo motors, two precision gearboxes, and a complete, integrated  arc voltage torch height control system. All this is installed and tested on a industrial grade, light ridged gantry designed expressly for plasma and oxy/acetylene cutting.

We offer both 4 and 5 foot gantries.  All of our gantry packages come with all racks and rails needed for both X and Y axis.  4 foot gantries are equipped for an 8 foot X axis cut.  5 Foot gantries are equipped for a 10 foot x Axis cut.

We can custom design a gantry/drive System for you if the following does not meet your needs. Call us for a quote….

When loading the plasma cutter, access from all three sides has some big benefits. Especially for the thicker materials.